今天是2018年1月24日 星期三,欢迎光临本站 合肥环瑞机械设备制造有限公司 网址: cnhuanrui.com

公司动态

雕刻机的日常保养

文字:[大][中][小] 2016-7-13    浏览次数:447    
雕刻机的日常保养

连续运行时间每天10小时以下,保证冷却水的清洁及水泵的正常工作,绝不可使水主轴电机出现缺水现象,定时更换冷却水,以防止水温过高。冬季如果工作环境温度太低可把水箱里面的水换成防冻液。

每次机器使用完毕,要注意清理,务必将平台及传动系统上的粉尘清理干净,定期(每周)对传动系统(X、Y、Z三轴)润滑加油。X、Y、Z三轴光杆用机油进行保养;丝杆部分加高速黄油;冬季如果工作环境温度太低,丝杆、光杆(方形导轨或圆形导轨)部分应先用汽油进行冲洗清洁,然后加入机油,否则会造成机器传动部分阻力过大而导致机器错位。

对电器进行保养检查时,一定要切断电源,待监视器无显示及主回路电源指示灯熄灭后,方可进行。雕刻机使用三个月左右要对紧固件进行检查,龙门两侧的连接螺丝、丝杠螺母的紧固螺丝、两侧电机的紧固螺丝进行紧固。


How to Maintain Engraving Machine

The working time of the engraving machine should be controled within 10 hours a day; keep the cooling water clean and maintain the operation of the pump; never let the water dry in the spindle, exchange the cooling water regularly to prevent the high temperature of the water; in winter, if the operating ambient temperature is too low, you can use antifreeze to instead of the water in the tank.

After using of the machine, pay attention to clean up, make sure to clean up the dust on platform and transmission system, to lubricate and refuel the transmisson (X,Y,Z axis) system regularly(weekly); use the engine oil to maitain the X,Y,Z axis; add high-speed butter at screw part; if the working temperature is too low in winter, the screw and polished rod (square rail or round rail) part should be rinsed with gasoline, then add engine oil, otherwise the high resistance of the transmission parts will make the CNC router dislocation.

When you do the electrical maintenance checking, make sure to cut off power supply. after the monitor has no display and the main circuit power indicator light turns off, it can be carried out. after using the machine around three month, you should check the fastener, and tighten the screws of both sides of the gantry, the screw nut and both sides of the motor.




返回上一步
打印此页
[向上]

网站首页

产品中心

公司介绍

资讯动态

联系我们

在线询单